0
Comment
Platform Cable USB - Programmer and Debugger for Xilinx Devices
3.914,00
TL
+
VAT
4.696,80
TL
Notify Me When It Arrives
Notify Me When It Arrives
Platform Cable USB - Programmer and Debugger for Xilinx Devices
The Platform Cable USB is a USB-compatible cable used for in-circuit configuration and programming of all Xilinx devices.
Features
- SKU: 6530
- Performance
- New hardware solution based on CY7C68013A+FPGA; compatible with the original XILINX Platform Cable USB and Platform Cable USB II.
- Programs all Xilinx devices, including FPGAs, CPLDs, and ISP configuration PROMs.
- Supports JTAG, Slave-Serial, and SPI programming methods for configuring all Xilinx devices.
- Can interface with devices operating at voltage levels of 5V, 3.3V, 2.5V, 1.8V, and 1.5V.
- Offers selectable target clock frequency; Supports automatic frequency adjustment via XILINX software.
- Features automatic firmware updates, ensuring support for newly released software and devices.
- Includes anti-static protection and multi-layer signal isolation to safeguard both the target system and the programmer itself.
- Comes with an adapter board and various cables to facilitate easy connection to official development boards or other circuit boards.
- Supported Software
- Xilinx ISE
- iMPACT
- ChipScope
- Vivado
- Supported Devices
- Xilinx FPGA devices: UltraScale / 7 series / Zynq / Kintex / Virtex / Artix / Spartan, etc.
- Xilinx CPLD devices: XC9500 / XC9500XL / XC9500XV / CoolRunner XPLA3 / CoolRunner-II, etc.
- Xilinx PROM devices: Platform Flash XCF00S / XCF00P / XL, etc.
- LED Status Indicators
- Red: USB connection active
- Yellow: USB connection active and Vref (target board) supply present
How to Connect?
- Connects to PC
- Via USB interface
- Connects to target board
- The Platform Cable USB offers 3 different interfaces for connecting to the target board: JTAG, Slave Serial, and SPI. The figure below shows the connector pinout for these interfaces:

Note: To prevent damage to the Platform Cable USB, please ensure that the VCC and GND connections are made correctly.
Package Contents
- Platform Cable USB main unit x1
- JTAG adapter x1
- USB cable x1
- 8-pin header to 7-pin flying-lead cable adapter x1
- 8-pin header to 6-pin header adapter cable x1
- 14-pin (2.54 mm pitch) JTAG cable x1
- 14-pin (2 mm pitch) JTAG cable x1
- 10-pin (2.54 mm pitch) JTAG cable x1
SIMILAR PRODUCTS
.png)

















